V-groove doors — tongue and groove, from a single board
Through-section
A V-groove door is the panelled-board look done properly: fine 45° grooves machined straight across a single sheet, at an even spacing we calculate for your door size. It reads as tongue-and-groove boarding from across the room, but there are no boards — nothing to shrink apart in a warm kitchen, and no joints to open up under the paint.
Tell us the door size and roughly how far apart you want the lines; we solve the count so the spacing lands dead even edge to edge rather than leaving a narrow board at one side. Runs can go vertical or horizontal, and it is the same cutter as our V-groove wall panelling, so doors and the wall behind them keep one rhythm.
What you get
- Fine 45° V-grooves at a calculated even spacing
- One-piece ultra-high-density MR MDF — no boards, no joints to open
- Vertical or horizontal runs, solved to your exact door size
- Matches our V-groove wall panelling — same cutter, same rhythm
V-groove doors for a cabinet system
Already buying the boxes? Every standard face size in v-groove, with the opening gap allowed for.
Frequently asked questions
Is this real tongue-and-groove boarding?
No, and that's the point. It reads as boarding from across the room, but it's one sheet with fine 45° grooves machined into it — so there are no boards to shrink apart in a warm kitchen and no joints to open up under the paint.
Can the grooves run horizontally?
Yes — vertical or horizontal, set in the configurator. The spacing is solved for the run's length either way, so the lines stay even end to end rather than leaving a narrow board at one edge.
How is this different from the Shaker V-groove?
Where the grooves go. This is a slab with grooves across the whole face; the Shaker V-groove is a recessed-panel shaker with a groove only along each rail and stile line, to imitate a five-piece frame.
Are these made to measure?
Yes. Every door is CNC-machined one-piece from moisture-resistant MDF to your exact width and height — enter the size in the configurator and the price updates as you type.
How are they made?
From a single sheet of ultra-high-density MR MDF, so there are no mitred corner joints to open or shadow through your paint.